Any one make their own AR tools?
I made a receiver vice block from some scrap wood. Took all of about 3 minutes, but of course I have a complete wood shop.
While I was at it, I took a bolt sized to fit the takedown pins, drilled a hole through it, cut off the head, smoothed it up and put a knob on it. Super easy to make.
Going to see if I can make a support block for installing the trigger guard pin.
I made a receiver vice block from some scrap wood. Took all of about 3 minutes, but of course I have a complete wood shop.
While I was at it, I took a bolt sized to fit the takedown pins, drilled a hole through it, cut off the head, smoothed it up and put a knob on it. Super easy to make.
Going to see if I can make a support block for installing the trigger guard pin.