Dpms Upper receiver
Pre 16" XT barrel (non chrome) from AR performance
YHM mid length light rail
Railed gas block
New 6.8 stag bolt
New firing pin, cam pin, firing pin retainer
I built this before my xtremes came in. All it needs is a charging handle and bolt carrier w/ key. It has some scuffs on the flash hider and gas block where I removed them and put them on this build. The could easily be touched up with a gun blue(black) pen.
It does not come with charging handle and bolt carrier.
I'll consider trades. Scopes, handguns, auto shotguns.
Last edited by jasonpeterson; 08-15-2009 at 09:39 PM.
Reason: Received offer.
Cool...I wasn't sure how the pre XT barrels shot is why I was asking. As long as it slings lead I think I will be happy. Been looking for an upper to put on my Cavalry Arms lower for about 4 monts now. This will get my foot in the dor of the world of 6.8SPC.
I've been out bushhogging all day and figured I would shoot some groups to show what it will do. I only had 10 rounds of the same load with me. I used three to get it on target. Then I fired a three shot group at 100 yards. Then I drove back to 200 yards and shot a group of four. I was shaking from riding the tractor all day. I'm sure I was the limiting factor. I used a Leupold 3.5 to 10 scope. I used the target that we use for our forum competitions. I believe if I wasn't vibrating from the tractor I could have squeezed a little better groups out of it. It's a nice shooting upper.
Loads were ;
New SSA Brass
CCI 4 primers
29.5 grains of reloader 10x
110 pro hunters