6.8 SPC Forums banner

CH4D 6X6.8 Dies

1K views 1 reply 2 participants last post by  minnesotamulisha 
#1 ·
Hi fellas. Have been trying to run down a set of CH4D 6x6.8 sizing dies for my new upper I had built. I realize I could go the Redding bushing route, but I'd really like to get my hands in the CH4D one. Current production time from CH4D is over two months. Was wondering if there's anyone out there who could point me in the right direction.
Thank you!
 
You have insufficient privileges to reply here.
Top